![]() ![]() Requirement already satisfied: xmltodict in /usr/local/lib/python3.9/dist-packages (from hifiberrydsp) (0.12.0) Requirement already satisfied: zeroconf in /usr/local/lib/python3.9/dist-packages (from hifiberrydsp) (0.37.0) Requirement already satisfied: RPi.GPIO in /usr/lib/python3/dist-packages (from hifiberrydsp) (0.7.0) Requirement already satisfied: lxml in /usr/lib/python3/dist-packages (from hifiberrydsp) (4.6.3) Requirement already satisfied: pyalsaaudio in /usr/local/lib/python3.9/dist-packages (from hifiberrydsp) (0.9.0) Requirement already satisfied: spidev in /usr/lib/python3/dist-packages (from hifiberrydsp) (3.5) Using cached hifiberrydsp-0.20-p圓-none-any.whl (55 kB) Requirement already satisfied: hifiberrydsp in /usr/local/lib/python3.9/dist-packages (0.20) Python3-pip is already the newest version (20.3.4-4+rpt1). I2c-tools is already the newest version (4.2-1+b1). Get:3 bullseye/main armhf Packages Ġ upgraded, 0 newly installed, 0 to remove and 0 not upgraded. When I installed the beocreate-tools, at the end I had some errors, see below, could this be it? I tried using "-allow" but still $ sudo. I don't think there is a web server installed. I do not have a web gui, so doesn't work. I have already followed that link tutorial but I fail to continue when I need to upload the. Thank you in advance, I'm very excited about the product, it sounds great, it's awesome, I now just need a leash on it :). Initially I tried the hifiberryOS for beocreate and could use the controls including web gui, spotify etc, but the custom DSP from sigmastudio was clashing plus I need raspbianOS. Which of course wipes my profile, but still can't control the volume from cli. I even tried loading the profile as per another forum thread using Profile doesn't support volume $ dsptoolkit $ dsptoolkit mute Profile doesn't support volume $ dsptoolkit get-volume timeout TIMEOUT timeout in seconds (disabled, if $ dsptoolkit set-volume 30% host HOST hostname or IP address of the server to connect to delay DELAY delay for loop operations in ms h, -help show this help message and exit I tried using dsptoolkit from the command line following the help but nothing works. ![]() Now I want to control the volume from the raspbian cli, and later maybe more parameters, but initially the volume. So the board starts up automatically on the profile on boot up instantly. "Self-boot Memory - Write Latest Compilation Through DSP" in the Hardware Configuration tab. The profile created in sigmastudio is pushed to the DSP using I have installed the beocreate tools following the link:Īnd I have created a custom profile with sigmastudio, It has some complex auto eq curves and other processing. ![]()
0 Comments
Leave a Reply. |